100% Irish
Free Shipping When You Spend €100
30-day Money Back Guarantee
Online Since 2003

1Gb V-Data DDR2 PC2-5400 (667MHz) CL5 memory module by Adata


1Gb V-Data DDR2 PC2-5400 (667MHz) CL5 memory module Image
No longer available. See alternative options

Key Features

  • 1Gb
  • PC2-5400 (667MHz)
  • Single 1Gb module
See full specifications
See product description


Details
1Gb DDR2-667 PC2-5400 memory module for desktop systems. Non-ECC module, 240-pins, unbuffered, 1.8V, CL5. From A-Data - one of the largest memory manufacturers in Taiwan.

This is an excellent budget module, offering the best combination of reliability, performance and affordability.

By 1.8V low-voltage application, DDR2 modules can reduce about 50% power consumption, which is compared with 2.5V (DDR) power supply on the same operation speed. So it is an environment-friendly product. In order to achieve so amazing high operation speed, A-DATA applies the lower parasitic-loading FBGA (Fine-pitch BGA) package to run in full-speed without extraneous loading.

Compared with DDR, DDR2 owns four key technologies pave the way to high-speed operation and low power consumption.

4-bit prefectch
DDR2 archieves the high-speed by four times the transmission amount of data . It also doubles the data rate of DDR. In the 4-bit prefetch architecture, READ or WRITE can achieve the four times the amount of data in a really internal bus clock. This is why the DDR2 can operate in four times faster than the internal operation frequency.

ODT (On Die Termination)
In DDR2, it is composed the termination resistor inside which is applied to match the transmission impedance on the mainboard. It will greatly attenuate the reflected noise resulted from last signals which improves a clear logic-level to avoid the reception of error data.

OCD (Off Chip Driver) Calibration
OCD is the Input/Output driver resistance which applied to adjust the cross-voltage to equalize the pull-up and pull-down signal. It will greatly help to the noise-rejected quality from DDR2 module to chipset in mainboard.

Posted CAS & Additive Latency (AL)
In a posted CAS (Column Address Strobe) operation, a CAS signal (READ/WRITE command) can be input to the next clock after RAS (Row Address Strobe) signal (active command) input. The CAS command is held by the module side and executed after the additive latency (0, 1, 2, 3 and 4). It is easier controller design by avoiding collision on the command bus, and improves the command and data bus efficiency due to simple command order. It also improves the practical memory bandwidth by removing the bubble.
Specifications
CAPACITY 1GB
STANDARD PC2-5400 (667MHz)
SINGLE MODULE OR DUAL KIT Single 1GB module
MEMORY SPEED 667MHz (DDR2-667)
CAS LATENCY CL5
MEMORY TIMINGS 5-5-5-15
VOLTAGE 1.8V
ERROR CHECKING Non-ECC
FEATURES 6-layer PCB
REGISTERED Unbuffered
TECHNOLOGY 240-pin DDR2 SDRAM
CONFIGURATION Double-sided 1GB memory module with 64Mx8 chips (16 chips)
PACKAGING Retail packaging
WARRANTY Lifetime warranty
User Reviews
No reviews yet
Add your review
 
Cookies help us deliver the best experience on our website. By using our website, you agree to our use of cookies. Learn more